ERROR DISPLAY Errors are displayed by the LEDs, and ink low warnings are displayed by the Status Monitor. Hp Compaq Dx7400 Microtower Pc Audio Drivers For Windows 7. Operator Call Error (Alarm LED Blinking in Orange) Alarm LED blinking Error Corrective action 2 times No paper Set paper, and press the Resume/Cancel button to feed the paper.
Resetter Canon ip2770 Free Download when we need to print something, the printer has an error, then you should re-check your printer. And should you need assistance. Canon Ws 1200h Manually more.
3 times Paper jam Remove the jammed paper, and press the Resume/Cancel button. 4 times No ink Replace the ink cartridge(s), or press the Resume/Cancel button to continue printing without replacing the ink cartridge(s).
5 times The ink cartridges are not properly installed, or a non-supported ink cartridge is installed (the ink cartridge EEPROM data is abnormal). Install the ink cartridges properly. Or, confirm that the supported ink cartridges are installed. 7 times Ink cartridge not installed Install the ink cartridge(s), and close the access cover. 8 times Waste ink absorber full or platen waste ink absorber full warning (approx. 95% of the maximum capacity) Pressing the Resume/Cancel button will exit the error, and enable printing. 14 times Non-supported ink cartridge installed Replace the non-supported ink cartridge with the supported one.
16 times Used ink cartridge installed, or no ink Pressing the Resume/Cancel button will exit the error, and enable printing. Carriage error or Error Code 5100 Condition: An error occurred in the carriage encoder signal. Problems and Solutions: • Smearing or scratches on the carriage slit film - clean the timing slit film. • Foreign material or paper debris that obstructs the carriage movement; - remove foreign material. • Ink tank conditions; - re-seat the ink tanks.
• If other solution fail, replace one off the following - Timing slit disk film - Carriage unit - Logic board - Carriage motor Line Feed error or Error Code 6000 Condition: An error occurred in the LF encoder signal. Problems and Solutions: • Smearing or scratches on the LF / EJ slit film - clean the LF / EJ slit film. • Foreign material or paper debris in the LF drive; - remove foreign material.
Coments are closed